The Clean feature is ony available on select models. It allows you to add an additional backwash and rinse period to the beginning of every recharge cycle.
What is it?
The Clean feature adds an additional fast rinse period to your normal recharge cycles. We recommend using this feature if you have a water supply that carries high amounts of sediment or iron to help preserve the resin capacity.
Programming
We recommend starting low and increasing the duration of this cycle over time if needed. This will allow for higher efficiency and water conservation.
1. Hold the Program button down until '000' appears, then let go.
2. Tap the Program button twice to display 'Clean' and 'OFF' on the screen. Use the Up or Down arrow to switch this 'ON'.
3. Tap the Program button again to chose the duration of the clean cycle using the Up/Down arrows. This can be set from 1 to 15 minutes.
4. Continue tapping the Program button until you return to the home screen with the current time.
Comments
5 comments
Then the clean will start automaticaly? After setting it to on?
The Clean feature only runs during a recharge cycle. After turning the Clean ON, your softener will add an extra cleaning to each recharge cycle it runs.
Thanks for your reply! I set it at 3,
So I guess it will run even with a manual recharge.
“We recommend starting low and increasing the duration of this cycle over time if needed.”
How would I know if I need to increase the duration? My WHESFC defaults to 6 minutes, so I left it there. The manual says the default is 2 minutes, but that is not what I saw.
Mas Kato,
Thank you for your comment! We have updated the article to be more informative regarding the use of this feature. Generally, we only recommend using this feature if you have a large concentration of sediment or iron in your water. We've created a ticket for you to ask any additional questions about this feature to our team - you can expect an email notification for that.
Please sign in to leave a comment.